►The PCM-S series support rod of Ø6mm can be inserted inside;
►The stud type has 4-40 studs and M3 studs to choose from;
►It is convenient to add/remove parts to the cage-type component device;
►Precision processing of stainless steel, high flexibility of building blocks, high applicability of alignment;
(1) The cage rod adapter is convenient to separate the cage components when adding or removing components. The building block has high flexibility, can simplify the alignment steps, and facilitate the installation and integration of the cage system
(2) There is an inner hole at one end of the adapter. Unscrew the fastening screw to be compatible with Ø6mm cage rods. Tighten the M4 fixing screw on the side with a 2.0 mm hex wrench to fix the position of the support rod. The other end of the adapter is an externally threaded stud, which can be 4-40 stud or M3 stud. Used to screw in another cage rod or 4-40/M3 internal threaded cage assembly. There is a Ø2.3mm through hole in the middle of the side of the building block, which can provide extra leverage and tighten with tools.
One end of the M3 thread can be directly connected to the OPS-M2 universal base plate, and a 30 mm cage system component is installed vertically on it, which provides a multi-threaded mounting hole array to install components in various directions, which increases the flexibility of the optical device.
Measurement error: Please allow a small measurement error.
- Additional Information