OPS-M406 Post Clamp Block Adapter Plate Bottom Plate Porous Position Mounting Plate Aluminum Flat Plate M4 To M6 Bottom Plate

Product information

Characteristic

►The conversion board provides mounting holes suitable for most directions, which increases the flexibility of the optical device;

►Install the post bracket through the M6 countersunk hole at the bottom;

►Install on breadboard or optical table through countersunk holes for M4/M6 cap screws;

►The counterbore on the adapter plate can also enable the imperial optical table to accept metric components;

Description

(1) There are mounting holes used in almost all optical tables and breadboard threaded hole arrangements, which can flexibly assemble optical equipment. The optical element or platform can be installed in any direction.

(2) OPS-M406 countersunk holes have 4 M4 and 4 M6 (the front panel has 4 openings); there
are 24 M4 and 17 M6 threaded holes; OPS-M406A has 4 M4 and 4 M6 countersunk holes (2 openings on the front and rear panels); threaded holes have 24 M4 and 17 M6;

(3) It can be used with post clamp block, post bracket, translation stage, etc. This combination design of clamping block and panel can be used to install opto-mechanical components with different requirements.

Compared with OPS-M406,OPS-M406A is more suitable for the stable connection of post clamps, because its front and rear panels have two M6 countersunk holes.

Measurement error: Please allow a small measurement error.