OPH-B Series 66mm Optical Guide Rail Fixed Bracket Guide Rail Slider Linear Slide Table Slide Rail Stage Scientific Research

Product information

Characteristic

1,60mm Rail Features:

►66mm optical rail;

►Rail length range is 200mm-750mm;

►OPH-B series wireless slot; OPH-R series - open cable slot at the end to facilitate the regular direction of the line;

►Compatible with OOP-M series of rail sliders;

►The corners on both sides. There are 4 M3 threaded holes on each;

►Ø55mm clear aperture through the guide rail;

2,Slider Features:

►It can be inserted or removed anywhere along the side of the 60mm guide rail;

►You can slide along the side of the guide rail before locking;

►Compatible with OPH-B series optical rails and CAX-R series lifting brackets;

►The table has various screw holes, suitable for carrying optomechanical devices;

3,Rail Bottom Plate / Bracket Base Features:

►The 66mm optical rail can be installed on the breadboard;

►With OOP-MA sliding block installed horizontally, the position of the guide rail can be adjusted by sliding;

►The vertical mounting base is fixed to the end of the guide rail, 66mm guide rail can be installed as a fixed bracket;

4,66mm Bracker Cover  Features:

►OPS-MO cover plate can form a shading closed environment in the bracket;

► The OPS-MC cover provides additional ports with wireway;

Description

(1) OPH-B series optical rail/bracket provides the necessary building blocks for the construction of stable and solid three-dimensional mechanical assembly. High flexibility, strong adaptability, provide a variety of device installation options.

(2) There are dovetail mounting surfaces on all four sides. They have dovetail mounting surfaces, which allow rails to be connected to each other or mounted on breadboards and other optical and mechanical accessories. The components mounted on it can slide uninterruptedly along the surface of the dovetail.

(3) OPH-B series guide rail can be used as a fixed bracket at the same time. The main body is equipped with rectangular groove guide rails on all four sides, which is compatible with OOP-MA and OOP-MX sliders. In the range of the vertical length of the bracket, the slider can freely move up and down the optical components mounted on it. The slider tail is fixed by two screws and can be operated with a 3mm hexagon wrench. The choice of the height of the support rails determines the vertical range that can be used by the experiment and
microscope components.

(5) The cover plate for 66mm rail/support has 4 countersunk holes of Ø4.4mm, which can be fixed on both ends of the support with M4 stud head screws. The OPS-MO cover can form a light-shielding enclosed environment in the rail/bracket; the OPS-MC cover provides an additional port with a wire slot.

 Measurement error: Please allow a small measurement error.