Characteristic▶Panel size: 600*400mm;
▶The middle groove part supports the device that can pass the light path from the front and side;
▶M6 screw hole array spacing 25*25mm, used to install various components;
▶There are 4 countersunk holes on the periphery to connect the breadboard to the optical table, post, bracket or other surface board;
▶Solid aluminum construction, low reflectivity anodized surface;Products DescriptionOHD-SP series special-shaped breadboards can be installed along the optical path of the microscope due to its groove and center through-hole design, supporting sample holders, micromanipulators or multi-component experimental devices. The platform panel M6 screw holes run through the breadboard, and the array spacing is 25mm.The panel of OHD-SP1 contains 312 M6 screw holes, and the groove part in the middle is 140*200mm in size, which supports multi-component experimental devices that can place optical paths from the front and side. The breadboard is different. The left and right panels have 4 06.5mm countersunk holes with a spacing of 50mm. The breadboard is mounted on two XY stage assemblies with micrometers for manual adjustment. Each manual stage assembly is in The mounted breadboard can be moved a certain range of travel on the X and Y axes. Move multiple individual components of a larger unit together.There are 278 M6 screw holes on the OHD-SP2 panel. There is a 0100mm hollow through hole in the center, and there are 4 M4 screw holes around the through hole, which provides convenience for building optical component prototypes, operating experiments and installing small subsystems. platform. The size of the groove part is 200*100mm, and a multi-component experimental device can be installed around the optical path of the microscope.The four corners of the breadboard have 4 countersunk holes, which do not occupy an array of threaded holes, enabling continuous installation of applications. The purpose of this counterbore is to attach the breadboard to an optical table, mounting post, mounting bracket, or other surface mount. For example, a 01.5" post mount can be used to elevate a breadboard off the work surface.Measurement error: Please allow a small measurement error.
- Additional Information