510nm-530nm Green Laser Module
-
$119.98Out of stock
0.8W 520nm Bird-Scaring High-Power Green Laser Module
-
$19.00Structured Light Source
3D scanning
3D modeling scannerIt is for lab use for test. 2-steps craft since the screw error, this laser can be used as lab test. when you need accurate effect with lower error, pls contact us
-
-
$121.991W Fat Beam Green Laser Diode Diode Laser Module Stage Lighting Effect with Fan -
$40.0020x20 Grid 520nm Green 3D Structural Light Source Lazer Scanner Grating Laser Module -
$20.40Out of stock
22*100 515nm 10mw Green Laser Dot Module for Cutting Engraving Machines
-
$29.98Specification:
1. Low Temperature turns on. This laser can work in winter for temperature at -25 centigrade
2. High temperature working: this laser can work on summer when the working temperature is over 40 centigrade.
3. Dust/water-proof cover which will protect the laser when it cuts stones or woods.
4. Bigger housing for longer duty cycle.
5. 12VDC adapter for more stable power supplyComparing with 532nm laser modules, this one is better at those areas:
1. wider working temperatuer from -25~45 centigrade
2. stable wavelength, no red bomb.
3. working in more seriously conditions. -
$31.0026*104mm Waterproof Red Green Line Generator Laser Module Generator for Stone/Wood/Feather Cutting
-
$36.48520nm 100mw Green Laser dot Module Diode Stage Lighting Long Duty 12VDC TTL -
$38.00Usage:
-
Stage lighting shows
-
Scare birds and animals
-
Laser curtain
-
Laser harp
-
Laser wine bar base
-
Escape room
-
Amusement park
-
Pleasure groud and squares
-
Holiday lighting effect
-
PM 2.5 PM 10 dust/humid testing
-
-
$40.00520nm 10*10mm Grid Green Light Grating Laser Module -
$40.00520nm 12V 20*20 1668 Rectangular grid Green Light grating laser module for 3d scanning -
$139.98520nm 1w Green Diode Laser Module for Escape Room Haunted House Stage Lighting Harp Curtain Bird Scaring DJ KTV BAR -
$249.00Out of stock
-
$540.00Features
1. Stage Lighting
2. PM2.5 PM10 testing
Instructions for use:
1 Connect the power plug before turning on the switch. Power is applied for 10 minutes into a stable state. Switching power supply interval should be greater than 5 seconds, or easily damaged lasers.
2 power panels should be placed on an insulator or overhead when using, otherwise it will bake a bad laser power. At the same time, and not let the laser power cables suffered at great force, so as to avoid the laser internal wiring circuit.
3 This laser is normally used on stage lighting shows, so that the heatsink by itself is not suitable for 7/24 working.
4 Please note that the use of dust, the dust can not be used in place much, if not a long time in the laser light hole stickers affixed dust. 5 This laser has a switch to adjust from TTL to analog.
-
$38.00Embeded Laser Head Bar KTV Ball Stage Light Laser Module TTL 520nm 200mw
