510nm-530nm Green Laser Module
-
$29.98Specification:
1. Low Temperature turns on. This laser can work in winter for temperature at -25 centigrade
2. High temperature working: this laser can work on summer when the working temperature is over 40 centigrade.
3. Dust/water-proof cover which will protect the laser when it cuts stones or woods.
4. Bigger housing for longer duty cycle.
5. 12VDC adapter for more stable power supplyComparing with 532nm laser modules, this one is better at those areas:
1. wider working temperatuer from -25~45 centigrade
2. stable wavelength, no red bomb.
3. working in more seriously conditions. -
$12.99Laser Curtain
Wine Base
Bar
KTV use
Stage Lighting
Escape Room
Haunted House
Halloween Holiday use
-
$31.0026*104mm Waterproof Red Green Line Generator Laser Module Generator for Stone/Wood/Feather Cutting
-
$19.98Laser Curtain
Wine Base
Bar
KTV use
Stage Lighting
Escape Room
Haunted House
Halloween Holiday use
Fan Cooling can work for long duty cycle
It can also be used by USB and power bank.
Can work with motorbike electronic system.
Easily installed on wall. -
$17.36520nm 30mw Green Dot Laser Module Diode DC/AC 12V Stage Lighting TTL 0-5V -
$36.48520nm 100mw Green Laser dot Module Diode Stage Lighting Long Duty 12VDC TTL -
$38.00Usage:
-
Stage lighting shows
-
Scare birds and animals
-
Laser curtain
-
Laser harp
-
Laser wine bar base
-
Escape room
-
Amusement park
-
Pleasure groud and squares
-
Holiday lighting effect
-
PM 2.5 PM 10 dust/humid testing
-
-
$14.00Function
1. Collimation
2. Alignment
3. Normally used for spinning machine
4. Haunted house use
5. Stage lighting use
6. KTV Lighting show
-
$4.50515nm 35mW Green Dot Laser Module dc7v 12*15mm -
$40.00520nm 10*10mm Grid Green Light Grating Laser Module -
$40.00520nm 12V 20*20 1668 Rectangular grid Green Light grating laser module for 3d scanning -
$139.98520nm 1w Green Diode Laser Module for Escape Room Haunted House Stage Lighting Harp Curtain Bird Scaring DJ KTV BAR -
$249.00Out of stock
-
$540.00Features
1. Stage Lighting
2. PM2.5 PM10 testing
Instructions for use:
1 Connect the power plug before turning on the switch. Power is applied for 10 minutes into a stable state. Switching power supply interval should be greater than 5 seconds, or easily damaged lasers.
2 power panels should be placed on an insulator or overhead when using, otherwise it will bake a bad laser power. At the same time, and not let the laser power cables suffered at great force, so as to avoid the laser internal wiring circuit.
3 This laser is normally used on stage lighting shows, so that the heatsink by itself is not suitable for 7/24 working.
4 Please note that the use of dust, the dust can not be used in place much, if not a long time in the laser light hole stickers affixed dust. 5 This laser has a switch to adjust from TTL to analog.
-
$8.00520nm Green Dot Line Cross Sewing Machine Positioning Laser with USB Connection -
$17.00532nm 50mW 520nm 35mw Green Fat Beam Laser Module KTV Party Club Stage Lighting
