Characteristic▶Compatible with CSK-A series clamp mounts, mount 30mm/60mm cage system to its surface plate.;
▶The threaded array of the panel enables vertical or horizontal installation of the cage system;
▶It can be used as the extension conversion plate of CFP-A25 post clamp;
▶ Compatible with CFP-A1.5 Post Clamps, mounts to our 01.5" Posts;
▶ Comes with 4 M6 stud screws for installation connection;Products DescriptionThe CFP-CSK clamp conversion block can be directly coupled to 025mm and 01.5 inch post clamp blocks. The thickness of the extension block of the adapter block is 21.0mm, which can lengthen and extend the distance to a certain extent. There are 2 countersunk holes in the center of the conversion block, which can be connected to the CFP-A25 post clamp and installed on the 025mm post. And there are 4 countersunk holes in the corners, which are compatible with CFP-A1 5 post clamps and can be installed on our 01.5" post.The conversion block surface plate has 8 M4 screw holes and 3 M6 screw holes. Compatible with our CSK-A Series Clamp Mounts, enabling vertical or horizontal mounting of a length of 30mm/60mm cage system components to it.The spacing between the countersunk holes on the four sides of the fixture conversion block is 50mm, which is suitable for the thread array of most Oeabt translation stages, such as linear translation stage series, angle tilt stage, etc. A section of 30mm/60mm cage structure can be loaded on the stage for use.
Measurement error: Please allow a small measurement error.
- Additional Information