Search results for 'red laser'
-
$11.00850nm 5.6mm Infrared IR Laser Diode LD 10mW 20mW 30mW 40mW 100mW 200mW 500mW 1W 2.3W -
$6,500.00RGB40W Laser with Color Light High-Power Laser Module
-
$14,000.00RGB60W Laser Stage Laser High-Power Color Laser Module
-
$4,335.00RGB30W Laser Color Light Laser Stage Laser Module High-Power Laser Module
-
$350.00Mixed RGB White Laser
-
$7.00 -
$121.991W Fat Beam Green Laser Diode Diode Laser Module Stage Lighting Effect with Fan -
$475.00Laser Diode 450nm 4.75*8W 38W numb08 bank extracted from laser projector. -
$187.506W 450nm Engraving Blue Laser Module can work on stainless steel -
$36.00Out of stock
laser bank 24v-36v boost driver board power supply for nichia blue laser diode bank
-
$249.00Out of stock
-
-
$110.00450nm 5.5w Engraving Marking Engraver/Marker for wood/plastic/stainless steel
-
$375.00
Specification
Wavelength: 905nm
Output: 25w
It is IR laser,the laser light cannot be seen by human bare eyes with only using DDC/infrared camera get it.
-
$234.00Out of stock
Nichia NUMB08 38W 450-460nm Blue Laser Diode LD Bank -
$540.00Features
1. Stage Lighting
2. PM2.5 PM10 testing
Instructions for use:
1 Connect the power plug before turning on the switch. Power is applied for 10 minutes into a stable state. Switching power supply interval should be greater than 5 seconds, or easily damaged lasers.
2 power panels should be placed on an insulator or overhead when using, otherwise it will bake a bad laser power. At the same time, and not let the laser power cables suffered at great force, so as to avoid the laser internal wiring circuit.
3 This laser is normally used on stage lighting shows, so that the heatsink by itself is not suitable for 7/24 working.
4 Please note that the use of dust, the dust can not be used in place much, if not a long time in the laser light hole stickers affixed dust. 5 This laser has a switch to adjust from TTL to analog.
