Search results for 'green laser'
-
$14.00Function
1. Collimation
2. Alignment
3. Normally used for spinning machine
4. Haunted house use
5. Stage lighting use
6. KTV Lighting show
-
$119.98Out of stock
0.8W 520nm Bird-Scaring High-Power Green Laser Module
-
$24.00Green Dot Matrix Laser Module
-
$121.991W Fat Beam Green Laser Diode Diode Laser Module Stage Lighting Effect with Fan -
$19.00Structured Light Source
3D scanning
3D modeling scannerIt is for lab use for test. 2-steps craft since the screw error, this laser can be used as lab test. when you need accurate effect with lower error, pls contact us
-
$14.00Out of stock
14*50 520nm 5mW Green Cross Laser Diode Module for Alignment and Position -
$9.00520nm Green Fat Beam Laser Module KTV Party Club Stage Lighting -
$6.501328 532nm Green Laser Module Stage Light Module 20mW -
$4.50515nm 35mW Green Dot Laser Module with no Driver 12*15mm -
$7.99Red Spot Laser Head Module Button Marking Machine Positioning Focusable 10mm Diameter Cylinder 3-5V
-
$39.99This laser adopts an imported 520nm green laser diode, that a green laser diode directly emits light. The non-808nm laser diode is converted into a 532nm green laser by a crystal. It can start and work at low temperature. The laser has a pure color and a long continuous working time, suitable for industrial and stage lighting scenes.
-
$249.00Out of stock
-
$69.98Out of stock
Focusable 12*55 powell lens 110 degree Green 510nm 10mw Laser Line Module for Machine Vision use -
$8.001235 510nm Green Cross Hair Laser Module -
$8.001235 510nm Green Line Laser Diode Module -
$540.00Features
1. Stage Lighting
2. PM2.5 PM10 testing
Instructions for use:
1 Connect the power plug before turning on the switch. Power is applied for 10 minutes into a stable state. Switching power supply interval should be greater than 5 seconds, or easily damaged lasers.
2 power panels should be placed on an insulator or overhead when using, otherwise it will bake a bad laser power. At the same time, and not let the laser power cables suffered at great force, so as to avoid the laser internal wiring circuit.
3 This laser is normally used on stage lighting shows, so that the heatsink by itself is not suitable for 7/24 working.
4 Please note that the use of dust, the dust can not be used in place much, if not a long time in the laser light hole stickers affixed dust. 5 This laser has a switch to adjust from TTL to analog.
