Search results for 'green laser'
-
$8.90520nm Thick Beam Green Laser Module for KTV Bar DJ Stage Lighting Effects 30mW
-
$3.995V 5mW 0611 Small Volume 515nm Green Dot Laser Generator Module Laserland
-
$8.00520nm Green Dot Line Cross Sewing Machine Positioning Laser with USB Connection
-
$139.98520nm 1w Green Diode Laser Module for Escape Room Haunted House Stage Lighting Harp Curtain Bird Scaring DJ KTV BAR
-
$19.98
Laser Curtain
Wine Base
Bar
KTV use
Stage Lighting
Escape Room
Haunted House
Halloween Holiday use
Fan Cooling can work for long duty cycle
It can also be used by USB and power bank.
Can work with motorbike electronic system.
Easily installed on wall. -
$12.99
Laser Curtain
Wine Base
Bar
KTV use
Stage Lighting
Escape Room
Haunted House
Halloween Holiday use
-
$38.00Embeded Laser Head Bar KTV Ball Stage Light Laser Module TTL 520nm 200mw
-
$14.00
Function
1. Collimation
2. Alignment
3. Normally used for spinning machine
4. Haunted house use
5. Stage lighting use
6. KTV Lighting show
-
$121.991W Fat Beam Green Laser Diode Diode Laser Module Stage Lighting Effect with Fan
-
$17.00532nm 50mW 520nm 35mw Green Fat Beam Laser Module KTV Party Club Stage Lighting
-
$4.50515nm 35mW Green Dot Laser Module dc7v 12*15mm
-
$34.99
532nm Fat Beam Laser Diode Module Green Laser Head 80mW 8mm 5-24vdc Wide Voltage 22*90
-
$7.99
Red Spot Laser Head Module Button Marking Machine Positioning Focusable 10mm Diameter Cylinder 3-5V
-
$39.99
This laser adopts an imported 520nm green laser diode, that a green laser diode directly emits light. The non-808nm laser diode is converted into a 532nm green laser by a crystal. It can start and work at low temperature. The laser has a pure color and a long continuous working time, suitable for industrial and stage lighting scenes.
-
$18.00
green laser diode drive
1. laser point
2. for Jewelry Testing, we had checked
Jade and Brazil tourmaline Crack testing
Diamond, Ruby and saphire cutting surface testing
-
$540.00
Features
1. Stage Lighting
2. PM2.5 PM10 testing
Instructions for use:
1 Connect the power plug before turning on the switch. Power is applied for 10 minutes into a stable state. Switching power supply interval should be greater than 5 seconds, or easily damaged lasers.
2 power panels should be placed on an insulator or overhead when using, otherwise it will bake a bad laser power. At the same time, and not let the laser power cables suffered at great force, so as to avoid the laser internal wiring circuit.
3 This laser is normally used on stage lighting shows, so that the heatsink by itself is not suitable for 7/24 working.
4 Please note that the use of dust, the dust can not be used in place much, if not a long time in the laser light hole stickers affixed dust. 5 This laser has a switch to adjust from TTL to analog.